Centric Daylight LED Strip for Kitchen Under Cabinet Lighting

I want to use the Centric Daylight LED strip 4000K, so that requires the 24V power supply?

Yes, that is correct. Our CENTRIC DAYLIGHT LED strip lights are offered in 24 volts only, so you will want to ensure that you select the correct power supply voltage (24 volts).

Does the 16 AWG wire need to be stranded like speaker wire or can it be a single copper 16-gage wire?

​There are no firm requirements here as long as the wires can handle the current load. Single-strand copper wires would be fine at 16 AWG or thicker.

Can the solderless connector end of PN 3071 be disassembled and reassembled for installation purposes?

Yes, they can be detached and reattached numerous times. However, after multiple assemblies, the contact point may become less reliable over time (as the connector clamps need to bite down onto the circuit board), so we would recommend avoiding reassembly as much as possible. If absolutely necessary, you could cut one section of the LED strip section off to obtain a "fresh" LED strip connection point.

Is there any noise/whine created by the power supplies?

The units do not produce any audible noise, but if there are particular concerns about this, we would recommend testing before installation to double-check. As a worst-case scenario, we would be happy to have you return the units to use for a full refund.

Question posted under:

LED power suppliesLED strip lightsKitchen lighting

Related Knowledge Base Questions

‹   Knowledge Base Home